Just flashed – everything runs smoothly.
💾 dd if=cnc-auto-g156.img of=/dev/sdX bs=4M status=progress cnc-auto-g156.img
Here’s a draft post for — assuming this is a CNC machine firmware image, likely for a controller like Mach3, LinuxCNC, or an embedded system (e.g., Raspberry Pi / SD card image). Title: 🔧 CNC-AUTO-G156.IMG – Ready-to-use CNC control image Just flashed – everything runs smoothly
✅ Pre-configured for auto tool zero ✅ G-code stream stable up to 115200 baud ✅ LinuxCNC + Mesa card ready ✅ Homing & soft limits preset likely for a controller like Mach3
📁 MD5: f3a1c8b9e4d5f6a7b8c9d0e1f2a3b4c5